Monday 28 January 2013

Smooth as a babies.....

I'd taken a scan of my partner when she was pregnant, but only just got around to cleaning it up ready for printing on the weekend. She was 38 weeks at the time of scanning. Unfortunately the head didn't work very well at all, so had to settle for just the torso.

Here is the original piece straight off the printer.




And here after 2 hours in an acetone vapour bath.



Saturday 5 January 2013

Smoothing

In an attempt to improve the finish of my models I have started experimenting with acetone vapour smoothing.

Stratasys offer a smoothing station for around $40,000 but I wanted something a little cheaper....

There are a few others on the net getting very good results with putting models in a cheap deep fryer or cooker and heating a small amount of acetone for a short period to vaporise the acetone and smooth the model.

Another option is to place the model in a sealed container with some acetone, and leave for a few hours. This method is the cheapest, but also the slowest.

A few things about acetone vapour. Firstly its rather toxic, so breathing it in is definitely not recommended. Its also explosive and evaporates at around 50C. And lastly it is around twice as heavy as air. This last point is somewhat of an issue with the passive smoothing method, as a part will smooth from the bottom up and so won't be even. On smaller models this doesn't really cause a problem, but when dealing with taller models I notice the bottom of the part looses more detail and can sometimes cause the part to warp or completely fall over, whilst layers are still visible at the top.

Ideally the vapour needs to be circulated around the part so as to get a good even covering. Something I'll work on in the future.

Another thing I noticed is that the part continues to smooth even after it has been removed from the container. I was quite happy with the result I had on a small figurine,so removed it from the container and left it on a bench to dry over night. In the morning I was shocked to find the part was far smoother than when I left it, and had lost much of the detail it showed the night before.

Now when a part is removed I put it into the freezer to halt any further smoothing.

Parts can vary on how long they need to stay in the vapour. depending on the size of the object and also the ABS. The dragon below for instance was left in for about 12 hours. Its relatively "soft" ABS, but the part was quite large. The terracotta warrior on the other hand was left in for just over 2 hours.


 Here you can clearly see the layers.

 This is the dragon after the smoothing vapour bath! The surface is as smooth as glass.
You can still just make out some layers, but these seem to be "underneath" and cannot be felt.

Another before ...
 And after